 |
|
 |
Imagine How Cool This All Aluminum Engine Is Going To Look In Your Hot Rod! Whether It's A '34 Roadster, An Early Nova Or Anything Else You Can Stuff A Small Block Chevy Into!!
- Horsepower
- Torque
- Bore & Stroke
- Compression Ratio
- Fuel Requirement
- 525 @ 5600 RPM
- 550 @ 4200 RPM
- 4.125 x 4.000
- 10.25 to 1
- 91 Octane
- World Products Aluminum Block w/Splayed 4 Bolt Main Caps
- Eagle 4340 4.000" Forged Steel Stroker Crank
- Eagle 4340 6.000" Forged Steel H-Beam Rods
- Clevite 77 "H" Series Main & Rod Bearings
- Mahle Custom Coated 10.25-1 Forged Aluminum Pistons
- Plasma Moly Ring Set
- SSRE/Comp Cams Custom Grind Hydraulic Roller Camshaft
- High Performance Hydraulic Roller Lifters
- Billet True Roller Timing Set w/Torrington Bearing
- Dart Pro 1 Platinum 215cc Angle Plug Aluminum Heads
- 2.080"/1.600" Stainless Steel Valves
- 1.470" Hydraulic Roller Springs w/Steel Retainers
- Custom Head Studs w/Heat Treated Washers
- Comp Cams Ultra Pro Magnum Roller Rockers
- Chromemoly (1) Piece .080" Wall Pushrods
- FelPro HP Head Gaskets w/Pre-Flattened Steel Wire
- Edelbrock "RPM Air Gap" Aluminum Intake
- Milodon Street/Strip Oil Pan w/Passenger Side Dipstick
- Milodon Race Prepped Oil Pump
- GM Performance Chrome Front Cover w/Billet Timing Pointer
- Hi-Performance Harmonic Balancer
- Complete Assembly Internally Balanced
- Individually Dyno Tested & Tuned
- Actual Dyno Sheet Provided
 |
 |
 |
|
 |
|
|
| Accessories: | ||
Billet Specialties Tru Trac Serpentine System |
|
$ Call |
Billet Specialties V-Track Pulley System |
|
$ Call |
| SFI Flex Plate w/ARP Bolts (Required At All Racetracks) | |
$ 125 |
JW "The Wheel" Severe Duty SFI Flex Plate |
|
$ 200 |
PowerMaster Hi-Torque Mini Starter |
|
$ 229 |
| Painless Performance Hot Shot Relay Kit (Recommended for above starter) | |
$ 39 |
Edelbrock Aluminum "High Volume" Mechanical Water Pump (Short or Long Version) |
SBC $175 • | BBC $ 195 |
Meziere 55GPH Electric Water Pump |
|
$ 375 |
| Polished Cast Aluminum Front Cover | |
$ 50 |
| Custom Powder Coating Packages Available | |
$ Call |
| EnduraShine Intake Finish w/ARP Stainless Steel Hardware | |
$ 195 |
| Carburetors & Fuel System: | ||
| Edelbrock 825 CFM Carb Package w/Electric Choke includes: Carb Spacer, Studs & Gaskets. Dyno Tuned and Jetted. Excellent Street Manners With Improved Cold Weather Starting & Increased Fuel Economy. Produces Slightly Less Peak Horsepower. | |
$ 595 |
| QuickFuel 780 CFM Vacuum Secondary Carb Package includes: Carb w/Billet Metering Blocks & Throttle Body, Electric Choke, AN Inlets, Studs & Gaskets. Dyno Tuned, Jetted and Calibrated on your engine. | |
$ 750 |
| QuickFuel 830 CFM Mechanical Secondary Carb Package includes: Carb w/Billet Metering Blocks & Throttle Body, Electric Choke, AN Inlets, Studs & Gaskets. Dyno Tuned, Jetted and Calibrated on your engine. | |
$ 765 |
| QuickFuel 950 CFM Mechanical Secondary Carb Package includes: Carb w/Billet Metering Blocks & Throttle Body, AN Inlets, Studs & Gaskets. Dyno Tuned, Jetted and Calibrated on your engine. | |
$ 895 |
| Mechanical Fuel Pump Package Includes: High Volume Race Design 6 Valve Pump, Fuel Pump Rod, XRP -8 Braided Fuel Line Inlet Kit w/8AN Lines, Fittings and Fuel Filter. Plumbed, Installed & Dyno Tested On Your Engine. | |
$ 395 |
Holley Billet Gerotor Electric Fuel Pump • Up To 750HP |
|
$ 195 |
Holley Billet Gerotor Electric Fuel Pump • Up To 900HP • Includes Regulator |
|
$ 235 |
| Chrome Edelbrock Dual Feed line with filter and AN fittings (for Edelbrock carb only). | |
$ 95 |
Weiand X-CELerator Intake. Over An Inch Lower Than Virtually Every Other Performance SB Intake. Slight Loss In Torque But Essentially The Same HP As The Edelbrock! Will Fit Under Stock Corvette Hood. |
|
$ N/C |
| Ignition System: | ||
| MSD HEI Ignition Package includes: Distributor, Cap, Built-in Coil, and Wires. Custom Curved and Calibrated on your engine. No additional Ignition Box needed. | |
$ 295 |
| MSD Electronic Ignition Package Includes: MSD Pro Billet Distributor, Hi Perf Gear, Custom MSD 8.5mm Wire Set. Custom Curved and Calibrated To Your Engine. | |
$ 395 |
| MSD 6AL Digital Electronic Ignition Box w/Hi-Speed Rev Limiter | |
$ 239 |
| MSD 6AL-2 Digital Electronic Ignition Box w/Launch Control & Hi-Speed Rev Limiter | |
$ 279 |
| MSD Blaster 3 Hi Performance Ignition Coil w/HEI Style Post | |
$ 49 |
| Shortblock Components: | ||
| Brodix/Dart Aluminum Block | |
$ 1250 |
 |
 |
|
If This Fuel Is Readily Available In Your Area, Our E85 Version Offers Much Greater HP And Torque Numbers Over Its' Gasoline Equivalent. E85 Fuel's Ability To Operate Without Detonation Under Much Higher Cylinder Pressure Allows Us To Significantly Raise The Compression Ratio And Slightly Alter Cam Timing To Produce These Dramatic Improvements. You Must Run An E85 Specific Carb Or Program Your Aftermarket Fuel Injection To Work With This Engine. |
|
|||||||||
 |
 |
|
You Asked For It And We Listened! We Struck A Deal With AFR To Get Some Of The Hottest Cylinder Heads On The Market And When Combined With Our Special "Proprietary Grind" Hot Hydraulic Roller Cam, "Ultra Hi-Rev" Hydraulic Roller Lifters and 1.6 Ratio Pro Magnum Rockers, The Power Is Up Over 40HP! |
|
AFR 210 Eliminator Fully CNC Ported Aluminum Heads Featuring 8MM Valves And AFR Competition Package Hydraulic Roller Springs
•
Comp Cams Custom "Proprietary Grind" Hydraulic Roller Cam
•
High Rev Hydraulic Roller Lifters
|
Components Subject To Change Due To Availability.
Free Freight Applies To All Advertised Items Shipped To A Commercial Address In The 48 States. Residential, Out-Of-Area Or Lift Gate Service Subject To Additional Charges. Insurance & Handling Fees Apply.
Toll Free: 800.295.7142 • Phone: 631.218.7530 • FAX: 631.218.7540 • Email: ssre123@aol.com
35 Davinci Drive • Bohemia, NY 11716
HOURS: Mon - Thu 9:00 a.m. - 6:00 p.m. Friday 9:00 a.m. - 3:00 p.m. EST
A Division Of Scott Shafiroff Race Engines & Components © 2000-2011 All Rights Reserved